how to print

[lizmccloskey]

hi guys im not a yu gi oh fanatic like yourselves, but my boyfriend is. for his birthday im making a yu gi oh with my face on it (ultra rare, 12 lvl, 0 atk 0 def.. the ultimate netflix slug monster) 

 

i know how forums work and there's probably a similar post where someone is asking about printing the cards but bear with me please. 

 

when i save my card design and go to print it, will it be the right size? i want to know if ill have to edit the proportions to make sure to fit a card sleeve. i plan to print it, cut it out and glue it to an unwanted yu gi oh card he didnt want.  

 

also, the photos that i upload dont fit properly, is there a way to make them fit? theyre very squished atm

 

any information is appreciated.

thank you!!!!!!!! :) 

[Flash Flyer - Sakura]

1. When you upload images, they should ideally be square (no smaller than 319px x 319px). If they aren't square (or close to it), then the cardmaker will either stretch it and possibly make it pixilated or in your case, squish it. If your source image isn't square, either crop the area you want on the card.

 

2. Card made here render as 419 x 610 pixels by size. A real card is roughly 2.375'' x 3.625'' (just multiply the dimensions by 2.54 if you use the metric system). Not too sure what size that will generate as in pixels [GIMP gives 177 x 261 pixels, but test it first]. Either that, or you may wish to add it as a picture on a word document and size it there.

 

Just check if the card from here will render as the appropriate size.